Product Descriptions

NY8A054E is an 8-bit microcontroller designed for multi group PWM applications, with EPROM as the memory. For example, light control and remote control car applications. Adopting CMOS process while providing customers with significant advantages such as low cost, high performance, and high cost-effectiveness. The NY8A054E core is built on the RISC reduced instruction set architecture, making it easy to edit and control, with a total of 55 instructions. Except for a few instructions that require 2 timings, most instructions can be completed in 1 timing, allowing users to easily control different applications through programming. Therefore, it is very suitable for various complex applications with low to medium memory capacity.

In terms of I/O resources, NY8A054E has 14 flexible bidirectional I/O pins, each with a separate register to control as an input or output pin. And each I/O pin has additional program control functions such as pull-up or pull-down resistors or open drain outputs. In addition, for infrared remote control products, NY8A054E has a built-in infrared carrier emission port with selectable frequencies.  

NY8A054E has three sets of timers, which can be used as general timing applications with system frequency or triggered by external signals to count. In addition, NY8A054E provides 5 sets of 10 bit resolution PWM outputs, and 1 set of buzzer output can be used to drive motors LED、 Or buzzers, etc.

Products Features

Wide operating voltage:

2.0V~5.5V @ system frequency ≤ 8MHz.

2.2V~5.5V @ system frequency>8MHz.

Wide operating temperature: -40 ° C~85 ° C.

2Kx14 bits EPROM.

128 bytes SRAM.

14 I/O pins (GPIO), PA [7:0], and PB [5:0] that can independently control the input and output directions.

PA [5:0] and PB [3:0] can choose to use built-in pull-down resistors for input.

PA [7:0] and PB [5:0] can choose to use pull-up resistors for input.

PB [5:0] can select open drain output.

PA [5] can be selected as input or open drain output.

8 layers of program stack.

There are direct or indirect addressing modes for accessing data.

A set of 8-bit countdown timers (Timer0) includes programmable frequency pre division lines.

Two sets of 10 bit countdown timers (Timer1, 3) can be selected for repeated loading or continuous countdown.

Five 10 bit pulse width modulation (PWM1, 2, 3, 4, 5), with PWM1/2 sharing Timer1; PWM3/4/5 share Timer3.

One buzzer output (BZ1).

38/57KHz infrared carrier frequency is available for selection, and the polarity of the carrier can also be chosen based on the data.

Built in accurate low voltage detection circuit (LVD).

Built in accurate voltage comparator.

Built in power on reset circuit (POR).

Built in low voltage reset function (LVR).

Built in watchdog timer (WDT), which can be controlled on/off by the program firmware.

Built in Resistance Frequency Converter (RFC) function.

Dual clock mechanism, the system can switch between high-speed oscillation or low-speed oscillation at any time.

Specifications

Actual product photos

Payment&Transportation

Official Certificate&Certificate

Multiple product supply

Company office environment

Warehouse Real Shot

Standard packaging

We also provide ：