Product Parameter

【 Working voltage 】: DC5-50V, maximum 50V

【 Output voltage 】: Adjustable from 1.25-30V

【 Minimum Voltage Difference 】: The input voltage must be at least 2V higher than the output voltage and cannot be boosted

【 Output current 】: 12V to 5V, maximum 3A (calculate other voltages according to the formula of 15W/output voltage=output current)

【 Output Power 】: Maximum 15W (If the temperature is high, please install a heat sink)

【 Conversion efficiency 】: 80% (the higher the output voltage, the higher the efficiency)

【 No load current 】: around 10mA

【 Output Short Circuit Protection 】: Yes, constant current (currently set constant current value)

【 Input Reverse Connection Protection 】: Yes

【 Constant current range 】: 0.2-3A (adjustable, default to 1A)

【 Turning current 】: Constant current value * (0.1), the turning current is linked to the constant current value. For example, if the constant current value is 3A, the turning current is set to 0.1 times the constant current (0.1 * 3A=0.3A). When the constant current value is adjusted to 2A, the turning current is 0.1 times the constant current (0.1 * 2A=0.2A). This version is fixed at 0.1 times (used to identify whether the battery is fully charged during charging)

Product Use

Instructions:

Battery charging usage method:

a. Determine the float charging voltage and charging current of the rechargeable battery you need, as well as the input voltage of the block；

b. Adjust the constant voltage potentiometer to adjust the output voltage to around 5V；

c. Measure the output short-circuit current with a multimeter in 10A current mode, and adjust the constant current potentiometer to achieve the predetermined charging current value;

d. Adjust the constant voltage potentiometer to make the output voltage reach the float charging voltage;

e. Connect the battery and try charging.

(Steps 1, 2, 3, and 4 are to connect the module input to the power supply and the output to no load without connecting the battery.)

Usage of LED constant current driver:

a. Determine the operating current and maximum operating voltage required to drive the LED;

b. Adjust the constant voltage potentiometer to adjust the output voltage to around 5V.

c. Measure the output short-circuit current with a multimeter in 10A current mode, and adjust the constant current potentiometer to achieve the predetermined LED operating current;

d. Adjust the constant voltage potentiometer to achieve the maximum working voltage of the LED output voltage：

Connect the LED and test the machine.

(Steps 1, 2, 3, and 4 are to connect the module input to the power supply and output without connecting the LED light when unloaded.)

Product Special note

1. Pay attention to wiring according to the diagram and do not make mistakes!

2. This document only represents the product knowledge and parameters at the time of editing, and any changes in the future will not be notified separately.

3. The input voltage cannot exceed 50V, and the output voltage cannot exceed 3A.

4. If the output current is greater than 2A or the output power exceeds 10W, and if working for a long time, please strengthen heat dissipation

5. If the ambient temperature exceeds 40 degrees, please reduce power consumption or strengthen heat dissipation

Product Size

Product Show

Payment&Transportation

Official Certificate&Certificate

Multiple product supply

Company office environment

Warehouse Real Shot

Standard packaging

We also provide ：